This is the Mode 2 Helicopter Version Futaba 10CG Transmitter and R6014HS 14-ch Receiver with the 2.4GHz FASST system. No Servos Included.
This heli version will default to helicopter settings, with mode 2 stick operation when powered up and has a non-ratcheted throttle stick.
Futaba’s FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and interruptions unlike other 2.4GHz systems that only stay on one or two frequencies.
Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude.
Graphics for programming swash plate types, swash ring and logic switches allowing timer activation or other function just by changing positions of specific sticks or functions 6 programmable heli mixes
8 swash plate types with graphics
5 point revo mixing
7 point throttle and pitch curves with delay
High/low pitch setting
Throttle hold and three idle-ups with delay
One year limited warranty
Futaba 10C Transmitter
NT8S700B 9.6V 700mAh NiCd Transmitter Battery , FUTM1460
NR-4RB 1000mAh NiCd Receiver Battery, FUTM1380
FBC-19B RX, TX Wall Charger, FUTM1830
R6014HS Receiver, FUTL7645
8″ (203mm) Servo Extension
Neck Strap, FUTM5690
Servos depending on type of aircraft
Power Supply: 9.6V NT8S700B NiCd battery Receiver
Receiving Frequency: 2.4GHz
Power Requirement: 4.8 – 6V
Current Drain: 70mA
Size: 2.06 x 1.48 x 0.63″ (52.3 x 37.5 x 16.0mm)
Weight: 0.72oz (20.8g)
This radio is available in the following default modes;
Air Mode 2, FUTK9255
Heli Mode 2, FUTK9256
Air Mode 1, FUTK9257
Heli Mode 1, FUTK9258